Category: 3D Weapon Modeling
-
PCAAR V2 (Fictional Rifle)
I decided to remake the gun that those soldier models I made (refer to the bottom of the post) use. I felt like the old one looked sloppy and forgettable, so instead of just improving it, I completely remade it! Just like the original, this model has bones and can be posed. A look at…
-
Enemy soldier V2
This is not necessarily a remake, but more like an improvement of my older enemy soldier model. Many improvements were made with topology, detail, and general design. The model has bones and can be posed, just like the original. A closer look at the chest rig. On this iteration, I decided to move the machete…
-
M4 Reload
I animated the M4 I modeled awhile ago reloading. Here is the gif. The original model in case you want to see it.
-
Sword with a lot going on
You know it’s bad when I have to say that. Not even sure how to explain all the features of this sword. The model has bones and can be posed. The weapon with the cylinder removed and the ripcord pulled. The sword’s chainsaw part moving.
-
Abrasive Sword
This is a sword (really abstract concept of one anyway) that I came up with that uses a column of abrasive material as the blade. The column is rotated at supersonic speeds by a motor that is built into the grip of the sword. This high-speed rotation is able to essentially sand through even super…
-
Roy 3.0
The latest (at the time I’m writing this at least) iteration of Roy! There were way too many problems with the old model (bad topology, unnecessary detail on areas where it wouldn’t make a difference, gross fish face) so a large amount of this model was completely remade. This model (just like the last two)…
-
Pure sword and slate sword
Here are two variations of a sword I Designed for Arvamond. The “normal” looking one is called the pure sword and the melted looking one is called the slate sword. A look at the sword hilt to show the etching detail. The hilt of the slate sword. I tried to make the melted parts look…
-
AKS-74U
This is my take on the AKS-74U (also known as the “Krinkov”), An Ak variant designed to be more compact. This model is fully rigged and can be posed, like most of the models I make. A look at the magazine detached from the gun. The bullets are pretty low poly to conserve tris. I…
-
Not a katana
This very strange sword is my idea of what would happen if you gave a katana blade to a European blacksmith to finish. The intricate engravings were done using a bumb map and a texture I made. A look at the model not in rendered mode. While it doesn’t have very many, this model has…
-
Ice Sword
A magic sword I came up with. Fire swords are far too common, so this one uses ice! The way it works is it sucks moisture from the air towards the blade and freezes it into a massive icicle blade. The sword with all of it’s acessories. The model has (very few) bones and can…